Perimeter repair
Stretched corners are cut free and patched with termination bar where needed.
Flat Roofing
Rubber Roof Repair Bergenfield, NJ
A roofer in Bergenfield can repair a rubber roof by cleaning and priming the EPDM, then sealing open seams, punctures and torn flashing with rubber cover tape and lap sealant, so the roof stays watertight for more seasons. One call to (551) 374-2021 reaches a nearby rubber roof repair pro.
Rubber roofs fail in a few predictable places. The seams fail first on many older rubber roofs, because the original seam adhesive loses its grip after years of sun. Punctures and failed flashing at walls, curbs and vents round out the usual causes.
EPDM also shrinks as it ages. The membrane pulls away from walls and corners as it shrinks, stretching the flashing until it splits. Repairing shrinkage means relieving the strain and reflashing, not smearing sealant on the split.
Please do not reach for a can of tar. Petroleum-based patches attack the rubber and have to be scraped off before a real repair. For now, protect the inside, avoid the roof in wet weather and write down when the leak shows up.
Rubber Roof Repair is often paired with rubber roof installation and flat roof repair, depending on the cause.
Need rubber roof repair in Bergenfield? Call (551) 374-2021 to reach a nearby roofing contractor.
Call nowThe process
What happens during a rubber roof repair
A rubber patch is only as good as the cleaning and priming under it.
Inspect the roof
Seams, perimeter flashing and penetrations are checked first, since that is where most rubber roofs leak. If insulation is wet, it is cut out and replaced before patching.
Clean the rubber
The repair area is cleaned thoroughly, because dirt and chalky residue keep patches from bonding. Earlier tar repairs are cut away.
Apply primer
Primer goes on in a thin, even coat over the cleaned area. Skipping primer is the most common reason patches peel.
Seal the damage
A rubber patch extends well past the damage, gets rounded corners and is rolled to remove air. Odd shapes like pipe bases and inside corners get uncured flashing.
Seam repair
Open seams are cleaned, primed and covered with seam tape or a cover strip along their full length. Lap sealant protects the edges.
Wall flashing
Where the rubber has pulled away, the roofer relieves the tension, adds new flashing up the wall and secures it with termination bar. A termination bar holds the new flashing in place.
What is included
What rubber roof repair covers
Penetration flashing
Cracked pipe boots and vent flashing are replaced with pre-molded boots or uncured flashing.
Coating
An aged but sound roof can be primed and coated once all leaks are fixed.
Tear repair
Punctures get a primed rubber patch rolled for a full bond.
Seam repair
Failed seams get a new cover strip so they stay closed.
Related service
EPDM Roof Repair Bergenfield, NJ
Every EPDM repair depends on the same steps, done in order. Dirt, moisture or skipped primer are the usual reasons an EPDM patch fails. A bead of lap sealant seals the patch edges.
In Bergenfield, rubber roof repairs are best done on dry days when the membrane is not too cold. In an emergency, a temporary seal can stop water until conditions allow a proper patch. The permanent repair should still follow the full process.
Related service
Rubber Roof Replacement Bergenfield, NJ
Sometimes a rubber roof is too far gone to repair. Widespread seam failure, heavy shrinkage, cracking rubber or soaked insulation are signs replacement is due. A moisture survey helps decide.
Replacement options include new EPDM or a heat-welded membrane like TPO. Recovering may be an option over one dry layer, while wet areas require removal. Ask the Bergenfield roofer to compare repair and replacement for your roof.
Local help
Rubber Roof Repair Near Me
In Bergenfield, EPDM is one of the most common membranes on low slope sections of homes. Homes in Bergenfield and nearby places including New Milford, Dumont, River Edge and Cresskill get the most from an EPDM roof when seams and flashing are checked every year or two, and early repairs keep the insulation dry.
Need rubber roof repair around Bergenfield? Call (551) 374-2021 for a Bergenfield roofer who serves the towns around it too.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Bergenfield is busiest after a hard winter and before the next one.
Why call
Why not wait
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Roofers in Bergenfield know the roof types and weather wear common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Common questions about rubber roof repair
Why is my rubber roof pulling away from the wall?
EPDM shrinks slowly as it ages. Tension builds at walls and edges, and the flashing eventually tears. The fix is relieving the tension and adding new flashing.
Is roof cement safe for an EPDM roof?
Asphalt-based products damage rubber roofing. They attack the membrane and make future repairs much harder. Use primer, EPDM cover tape and lap sealant instead.
Can a rubber roof be coated?
A coating can extend the life of aging EPDM. The roof must be repaired first, cleaned and primed with an EPDM-compatible primer before an acrylic or silicone coating goes on. A coating is not a fix for an active leak.
How long does a rubber roof last?
A well installed EPDM roof commonly lasts 20 to 30 years. Thickness, installation and maintenance all affect its life. Repairs keep it on track.
What is the right way to patch EPDM?
A proper EPDM patch is a cleaned, primed and rolled repair. The roofer scrubs the area with membrane cleaner, applies primer, lets it flash off, then presses down a patch with rounded corners and rolls it firmly. Lap sealant finishes the edges.
More questions? Call (551) 374-2021
Related services
Rubber Roof Installation
EPDM rubber roof installation with the right thickness, attachment method and flashing details, planned around the slope and the building.
Learn moreFlat Roof Repair
Repairs for leaking flat roofs, from punctures and seams to clogged drains and wet insulation, after the real leak source is found, not guessed.
Learn moreRoof Coating
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.
Learn moreRoof Leak Repair
Leak repairs that fix the entry point, not just the ceiling stain, so the stain on the ceiling stops growing.
Learn more
Looking for something else?
See all roofing servicesTalk to a Bergenfield roofer about rubber roof repair
Call (551) 374-2021 for a local roofer in Bergenfield and nearby towns.