Ridge ventilation
Every wall, chimney and pipe gets new flashing, and a ridge vent caps the peak so the details match the shingles.
Shingle Roofing
Shingle Roof Installation Bergenfield, NJ
A roofer in Bergenfield can install a new shingle roof from the deck up: drip edge, ice and water shield, underlayment, starter strip, shingles, flashing and ridge vent, so the roof is sealed against wind-driven rain from the start. One call to (551) 374-2021 reaches a nearby roofer who installs shingle roofs.
What you see from the street is maybe half of a shingle roof. Below the shingles go metal drip edge, a self-adhering ice barrier at the eaves and valleys, a layer of underlayment and a starter row at the edges. Then come the flashing details and the ventilation, which decide whether the roof stays dry and how long the shingles last.
The first decision is the shingle itself. 3-tab shingles are thin and uniform, and architectural shingles are thicker laminated shingles with a textured, shadowed look and higher wind ratings. Impact-resistant shingles rated Class 4 under the UL 2218 test are an option where hail is common, and some insurers treat them differently, so ask yours.
Not every roof can take shingles. The usual minimum for shingles is a 2 in 12 pitch, with a double layer of underlayment on slopes up to 4 in 12. Flat sections are flagged during the estimate so the right material goes on each part.
Shingle Roof Installation is often paired with shingle roof replacement and roof installation, depending on the cause.
Dealing with this in Bergenfield, NJ right now? Call (551) 374-2021 to talk to a local roofer.
Call nowThe process
The order of a shingle installation
Here is the order a roofer follows on a new shingle roof.
Start with the deck
On a reroof or new build, the deck is inspected and fixed first, since shingles follow every dip beneath them. Shingles laid on a bad deck show every flaw.
Ice barrier first
Drip edge goes along the eaves, then ice and water shield runs up from the eave edge and down every valley. Where ice dams form, codes call for the barrier to reach beyond the warm wall line.
Cover the deck
Underlayment covers the deck in shingled rows, and the rake edges get their drip edge after it. Most roofers now use synthetic, which resists tearing and lies flatter than felt.
Start at the eaves
Starter shingles go on first at the eaves and rakes, putting a sealant line under the edge where wind lifts first. Without it, the first course has nothing holding its lower edge.
Shingle the field
Shingles go on in offset courses with nails in the marked nailing strip, and step flashing is woven in with each course along walls. Counter flashing laps over the step flashing at chimneys and walls.
Cap the roof
A ridge vent is cut in along the peak and capped with hip and ridge shingles, balanced with soffit intake at the eaves. Mixing ridge vents with box vents can short circuit the airflow.
What is included
Parts of a shingle installation
Eave membrane
The lowest edge of the roof gets a sealed membrane where ice dams and runoff hit hardest.
Choosing a shingle
3-tab, architectural or impact-resistant shingles are matched to the house so the look and performance both fit.
Drip edge
The edges get drip edge and starter shingles for a clean, sealed edge.
Deck underlayment
A synthetic water barrier goes over every sheet of decking as the second line of defense.
Related service
Architectural Shingle Installation Bergenfield, NJ
Installing architectural shingles uses the same layers underneath, with a few details specific to laminated shingles. Each nail has to pass through both layers in the marked nailing zone, which is narrower than on a 3-tab shingle. The ridge and hips get thicker cap shingles made for the line, not cut 3-tab pieces.
In Bergenfield, NJ, architectural shingles are the common choice for both new homes and reroofs. They resist wind, add depth to the roofline and outlast flat shingles. Color is worth picking in daylight against the brick or siding, since samples look different outdoors.
Related service
Asphalt Shingle Roof Installation Bergenfield, NJ
Asphalt shingles are the go-to residential roof, and installation quality is what separates a roof that lasts from one that does not. Most early leaks on new shingle roofs come from flashing, nailing or missing starter, not from the shingles. Ask what layers will go down before the shingles and how the valleys will be done.
A new asphalt roof in Bergenfield is usually installed in one to three days once the deck is ready. Shingles seal best in warm sun, so roofs installed in cold weather are often hand sealed along the edges. The crew will watch the forecast, since wet decking cannot be covered.
Local help
Shingle Roof Installation Near Me
New shingle roofs in Bergenfield go on everything from new houses and additions to reroofs of older homes. From Bergenfield out to neighboring towns such as New Milford, Dumont, River Edge and Cresskill, houses built decades ago tend to need ventilation and flashing upgrades when they get a new shingle roof, and a shingle chosen for local wind and hail makes sense anywhere storms roll through. If you are searching for a shingle roof installer near me, ask what goes under the shingles, not just which shingle goes on top.
Searching for shingle roof installation near me from Bergenfield or New Milford, Dumont, River Edge and Cresskill? Call (551) 374-2021 to talk to a roofer who works in your part of town.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Bergenfield is busiest after a hard winter and before the next one.
Why call
Why not wait
Drier ceilings
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Bergenfield
Local roofers see the same roofs and storm damage across Bergenfield and nearby towns.
Know what happens next
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about shingle roof installation
What is the best season for a shingle roof installation?
Shingles go on best in mild, dry conditions. In cold weather shingles get stiff and the sealant strips need sun to bond, so roofers handle them carefully and often hand seal the edges. Wet decking is the hard stop at any time of year.
How many nails should each shingle have?
Nail count and placement decide how well shingles stay on in wind. Four nails per shingle is common, with six where the shingle instructions or local code call for high-wind nailing. High or overdriven nails are a leading cause of blow-offs on newer roofs.
What kind of underlayment should go under shingles?
The layers beneath shingles are drip edge, ice barrier, underlayment and starter strip, in that general order. Felt still works, but synthetic is tougher and holds up better if the roof sits open. The shingle instructions and local code set the minimum.
What is the minimum pitch for asphalt shingles?
Shingles are made for slopes of 2 in 12 and steeper. Roofs that are low but still within range get added underlayment protection. Anything flatter needs a membrane roof such as TPO, EPDM or modified bitumen.
What is the difference between 3-tab and architectural shingles?
The difference is construction: one flat layer for 3-tab, two laminated layers for architectural. For most homes architectural shingles are the better value over the life of the roof. 3-tab can make sense on outbuildings or when matching an older roof.
More questions? Call (551) 374-2021
Related services
Shingle Roof Replacement
Full shingle roof replacement, from tear-off and deck repair to new shingles and flashing, including permits, cleanup and a final check.
Learn moreRoof Installation
Installing a new roof layer by layer, from drip edge and underlayment to flashing, vents and the finished roofing, whether it is asphalt shingles, metal or another material.
Learn moreRoof Ventilation
Roof ventilation work that keeps the attic dry in winter and cooler in summer, so shingles and decking last as long as they should.
Learn moreGutter Installation
New gutters and downspouts formed to fit the house, with the right size, pitch and outlet placement, from K-style aluminum to half-round and copper.
Learn more
Looking for something else?
See all roofing servicesGet shingle roof installation help in Bergenfield
Call (551) 374-2021 for a local roofer in Bergenfield and nearby towns.